Aironet AP4500 Manual de usuario descargar pdf (Pagina 11)

11

Running a Signal Strength Test (Strength)

See Page 4-9

Running a Carrier Test

This test will scan the frequencies for other RF signals. It will enable you to determine if there are other

radio signals in the band and assist in determining the best channel to use.

Using the Configuration Radio Extended Menu

Page 4-14

Balance

This setting determines if Load Balancing between Access Points is enabled.

Modulation

This selects the type of modulation for the 5.5 and 11Mb rates. All units in the system must be set to the

same modulation type to operate at the higher datarates. CCK is the modulation that is specified under the

proposed IEEE 802.11 specification draft for high speed LANS (5.5 and 11Mb).

Using the Configuration Ident Menu

Page 6-2

Aironet Access Point V7.05 Configuration Radio Extended Menu APXXXX_1419d8

Option Value Description

1 - Time_retry [ 8 ] - Number of seconds to retry transmit

2 - Count_retry [ 0 ] - Maximum number transmit retries

3 - Balance [ off ] - Load balancing

4 - Diversity [ off ] - Enable the diversity antennas

5 - Modulation [ cck ]

6 - Power - Transmit power level

7 - Fragment [ 2048 ] - Maximum fragment size

Aironet Access Point V7.05 Configuration Ident Menu APXXXX_1419d8

Option Value Description

1 - Inaddr [ 149.023.130.100 ] - Internet address

2 - Inmask [ 255.255.000.000 ] - Internet subnet mask

3 - Gateway [ 000.000.000.000 ] - Internet default gateway

4 - Routing [ menu ] - IP routing table configuration

5 - Dns1 [ 000.000.000.000 ] - DNS server 1

6 - Dns2 [ 000.000.000.000 ] - DNS server 2

7 - Domain [ "" ] - Domain name

8 - Nid [ 0040961419d8 ] - Network address

9 - Name [ "APXXXX_1419d8" ] - Node name

01 - Location [ "" ] - System location

02 - Contact [ "" ] - System contact name

03 - Bootp_DHCP [ off ] - Use BOOTP/DHCP on startup

04 - Class [ "AP4800E" ] - DHCP class id

Aironet AP4500 Manual de usuario Pagina 11