Aironet AP4500 Guía de usuario descargar pdf (Pagina 151)

11 - 6 Ethernet or Token Ring Bridge

Setting the Default (Source)

The default applies to those packets whose address does not have an

entry in the ﬁlter table.

Source address ﬁltering is “Off” by default. This saves processing power

since the unit has to look up the source address of each incoming packet

to see if a ﬁlter is to be applied. Before any individual source ﬁlters can

be made active, one of the other values for the default must be chosen.

You may set the action to:

n Off (no ﬁltering is done)

n Forward

n Discard

Displaying The Node Address Filters (Display)

Use the display option to view the table of controlled addresses. The

ﬁlters are stored in the association table so that they may be accessed

quickly. The display of the ﬁlters follows the format of the normal

association display. At the end of each line the ﬁlter action for each

address will be displayed.

This same display may also be produced using the “association display”

command with either the “all” or “multicast-ﬁlters” information. See

Chapter 10 “Setting Up the Association Table”.

NODE FILTERS

Address Device Type Parent Name Src

------------- --------- ---- ------------ ------------------ ---

N000102030405 Unkwn Fwd

Enter space to redisplay, q[uit]:

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 222 223

Sin comentarios

Aironet AP4500 Guía de usuario Pagina 151