Aironet PCI4810B Guía de usuario descargar pdf (Pagina 27)

Section 2: Using the WinDGS Utilities

OK, or by clicking on the X in the upper right hand corner of

the dialog box.

Status

The Status screen shows the current status from the PCI/

ISA Card. Status is updated at the rate specified by the

Screen Update Timer. Exit the Status screen by clicking on

OK, or by clicking on the X in the upper right hand corner of

the dialog box.

Link Test

You can use WinDGS to assess the performance of RF

links. TCP/IP protocol must be installed on your system to

run this link test. See the Windows 95/98/NT Help section

for more information on installing and setting up TCP/IP.

An IP address must also be configured for the Access

Point.

1. From the link test command menu, enter the following

parameters:

• IP address of Aironet Access Point:

This parameter specifies the IP address of the

Access Point with which you want to test the RF link.

Set this value before running the link test.

• Number of Packets:

This parameter specifies the number of packets the

link test will attempt to send. The display will show

the number of packets of the specified size that are

successfully transmitted and received. This parame-

ter is ignored if Continuous Link Test is selected.

• Packet Size:

This parameter specifies the size of the data packet

to be sent to the Aironet Access Point. Be aware that

the TCP/IP stack that comes with Windows 95 will

fragment packets greater than 512 bytes. Therefore,

the number of packets transmitted will not match the

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 83 84

Sin comentarios

Aironet PCI4810B Guía de usuario Pagina 27