Aironet 2200 Guía de usuario descargar pdf (Pagina 51)

Utilities 3 - 3

Statistics

The Statistics screen shows the current statistics from the Aironet Client

Card. Statistics are updated at the rate specified by the Screen Update

Timer. Clear the current statistics by clicking on the Reset button. Exit

the Statistics screen by clicking on OK, or by clicking on the X in the

upper right hand corner of the dialog box.

Status

The Status screen shows the current status from the Aironet Client Card.

Status is updated at the rate specified by the Screen Update Timer. Exit

the Status screen by clicking on OK, or by clicking on the X in the upper

right hand corner of the dialog box.

Linktest

WinDGS may be used to assess the performance of RF links. TCP/IP

protocol must be installed to run this link test. See the Help section of

Windows 95/NT for more information on installing and setting up TCP/

IP. An IP address must also be configured for the Access Point.

1. From the link test command menu, enter the following parameters:

IP address of Aironet Access Point:

This parameter specifies the IP address of the Access Point with

which you want to test the RF link. Set this value before running the

link test.

Number of Packets:

This parameter specifies the number of packets the link test will

attempt to send. The display will show the number of packets of the

specified size that are successfully transmitted and received.

Packet Size:

This parameter specifies the size of the data packet to be sent to the

Aironet Access Point. Be aware that the TCP/IP stack that comes

with Windows 95 will fragment packets greater than 512 bytes.

Therefor, the number of packets transmitted will not match the num-

ber of packets received (even if none are lost) if the packet size is

greater than 512 bytes.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 107 108

Sin comentarios

Aironet 2200 Guía de usuario Pagina 51